Reading a timegrapher without a watchmaking course
A timegrapher is a microphone and a bit of software. It listens to the ticks of the escapement and turns them into three numbers. Once you know what they mean, it becomes the best way to see how a watch is doing without opening the case.
Rate
Seconds gained or lost per day. Chronometer certification allows −4 to +6 s/day; most everyday movements are perfectly fine within ±15. More interesting than the number itself is how much it changes between positions.
Amplitude
How far the balance wheel swings, in degrees. A healthy movement on a full wind usually shows 270–310° dial up. Consistently low amplitude, below about 220° after a full wind, is the classic hint that the oils are tired.
Beat error
How symmetric the tick and the tock are, in milliseconds. Under 1.0 ms is fine, under 0.5 ms is good. It does not change with wear the way amplitude does.
My three watches
| Watch | Rate | Amplitude | Beat error |
|---|---|---|---|
| Hand-wound, 1970s | +9 s/d | 245° | 0.8 ms |
| Everyday automatic, 2019 | +3 s/d | 286° | 0.3 ms |
| Field watch, 2022 | −2 s/d | 271° | 0.4 ms |
All readings are dial up, about an hour after a full wind. Remember to set the lift angle to the value for your movement — 52° is the default, but some movements need a different setting, and a wrong lift angle shows up as a wrong amplitude.